6 GB
Ensure the product is mounted to provide ade-
quate heat-circulation.
Do not cover the product with blankets, cushions,
or similar heat insulating materials.
Use the product only with the parts described
in this instruction manual.
If the LED rope light
1
is not to be used for
any length of time (e.g. holidays), disconnect
it from the power supply.
Keep away from ponds and other water reservoirs.
Install the LED rope light
1
at least 2 metres
away from water containers. Avoid place that
might flood after heavy rainfall.
If using the LED rope light
1
outdoors, make
sure it is connected to a socket which is protected
with a faulty voltage protection switch (FI or RCD)
for a maximum faulty voltage up to 30 mA.
The LED rope light
1
is protected against
splashes of water (IP44) as long as the socket
meets the minimum protection standard.
Make sure the LED rope light
1
is not laid
down in areas where lawn mowers, trimmers,
scissors or similar cutting tools are used.
Do not pull the LED rope light
1
and make sure
it is laid down properly so that no one walks or
trips over it.
If in any doubt about the safe installation or
use of this product, please consult a qualified
electrician.
Installation safety instructions
Make sure that the product is only installed by
competent persons.
The LED rope light
1
can be installed on all
normally inflammable surfaces with the enclosed
mounting parts.
CAUTION! RISK OF ELECTRIC SHOCK!
Make sure that there are no power, gas or water
lines located where you wish to drill. Check with
a cable and pipe locator if necessary before
you begin drilling.
Before installation, check whether the surface is
suitable for the mounting parts and the weight
of the LED rope light
1
. If you are in any doubt,
consult an electrical specialist for advice.
Do not use sharp and / or pointed objects such
as wire, nails or fasteners for mounting.
Do not attach any additional objects to the
LED rope light
1
.
Avoid excessive bending of the LED rope
light
1
. This can damage the insulation.
The bending radius of the rope must not fall
below the following value: rope diameter
between 10–14 mm: 2 cm.
Avoid excessive heating of the LED rope light
1
.
A maximum of two sections of rope may cross
or run parallel to each other.
Installation
Note:
Remove all packaging materials from the
product before use.
First, please unroll the product before use.
Note:
The LED rope light
1
can be mounted on
all surfaces officially classified as being of “normal
flammability” by means of the supplied attachments.
Please fix the LED rope light
1
on the desired
surface and fix the product by attaching it with
the help of the included cable ties
3
.
Alternatively, you can also mount the product
by using the included attachment clips
2
. Firstly,
place the attachment clips
2
in a sturdy sur-
face and fix them with the included screws
4
by using a crosshead screwdriver.
Once the required attachment clips
2
have
been attached, you can press LED rope light
1
into the opening of attachment clips
2
. You
may further use the cable tie
3
to secure the
LED rope light
1
onto the attachment clips
2
if need.
Use
Plug the mains plug into the socket.
Please note that the product will still use some
energy even when the product has been switched
off if the mains plug is still plugged in. To switch
the product off completely, unplug the mains
plug from the socket.
