9
GB
Start-up / Operation / Cleaning and care
Start-up
Colour changing LED mood light
Place the LED mood light
1
on a level and
solid surface.
Connect the mains plug
20
to a socket. Verify
the available mains voltage matches the required
operating voltage of the product before use
(see „Technical Data“).
The LED mood light is now ready for use.
Remote Control (Fig. C)
Remove the insulating strip
17
between the
battery
16
and the battery compartment
13
on the remote control
2
before use.
Note:
Please note, the remote control uses
infrared light. The signal cannot be transmitted
„around the corner“ as radio waves do. Light-
tight objects may not be located between the
infrared diode
14
and the light.
Operation
Use the remote control
2
to select a light colour
or different colour change programs (Fig. A):
Selecting a light colour
Press one of the colour buttons
12
or the W
button
7
to select a colour corresponding
with the button colour.
Press the button
3
to gradually increase
the brightness.
Press the button
4
to gradually dim the
light.
Selecting the colour change
:
brighter
: dim
5 x R:
selects the desired colour
5 x G:
selects the desired colour
5 x B:
selects the desired colour
1 x W:
selects the desired colour
FLASH
button:
rapid colour change
STROBE
button:
slow colour change
FADE
button:
flowing colour change
SMOOTH
button: slow, flowing colour change
Switching off the light
If the LED mood light
1
is switched off with
the OFF button
5
on the remote control
2
,
the last colour or colour change selected will
be used when switching the light on again with
the ON button
6
.
However, if the LED mood light is disconnected
from the mains supply by unplugging it from
the socket, the LED mood light will always light
up white when switched on again.
Changing the battery (Fig. C)
Change the battery
16
when the range of the
remote control
2
noticeably declines or the LED
mood light
1
no longer responds to the remote
control.
Pull the battery compartment
15
out of the
remote control
2
.
Remove the battery
16
.
Insert the new battery
16
.
Only use the type of battery
16
specified in the
chapter „Technical Data“ and note the polarity
when inserting the battery. This is shown on the
back of the remote control
2
.
Slide the battery compartment
15
back into the
remote control
2
.
Cleaning and care (Fig. B)
Switch the LED mood light
1
off.
Remove the mains plug
20
from the socket
before you clean the light.
Clean the LED mood light
1
and the remote
control
2
with a dry, lint-free cloth.
Remove the glass ball
18
from the lamp base
19
by holding on to the lamp base
19
and
General safety instructions
