13
GB
Safety / Start-up
Introduction / Safety
poses a suffocation hazard. Children frequently
underestimate the dangers. Please keep the
product out of the reach of children at all times.
This product is not a toy.
This device may be used by children aged 8
years and up, as well as by persons with reduced
physical, sensory or mental capacities, or lack-
ing experience and / or knowledge, so long as
they are supervised or instructed in the safe use
of the device and understand the associated
risks. Do not allow children to play with the de-
vice. Cleaning and user maintenance should not
be performed by children without supervision.
Avoid the risk of fatal injury
from electric shock
Check the lamp for possible damage before
every use. Never use the light if it shows any
signs of damage.
CAUTION!
A damaged light means danger
of death from electric shock. In the event of dam-
age, repairs or other problems with the light
please contact the service centre or a qualified
electrician.
To avoid hazards, if the external flexible lead
on this lamp is damaged it must be replaced by
the manufacturer, their service representative or
an equivalent professional!
Before use, verify the available mains voltage
matches the required operating voltage of the
light (220–240 V∼, 50 / 60 Hz).
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances. Always unplug the LED-Driver prior to
assembly, disassembly, cleaning, or if the light
will not be used for extended periods.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
The light bulb is not replaceable.
This light is not suitable for dimmer or electronic
switches.
Only use the light with the included LED-Driver
(model EDP024V0240PB).
Prevent fire and injury
hazards
Do not look directly into the light source (light
bulb, LED etc.).
Do not leave the light or packaging lie about
carelessly. Plastic film or bags, plastic parts etc.
can turn into dangerous toys for children.
Never cover the light or the LED driver with ob-
jects. Excessive heat can result in fire.
Do not operate the lamp unattended.
Safe working
Mount the light so that it is protected from mois-
ture and dirt.
Always be attentive! Always pay attention to
what you are doing and proceed with caution
at all times.
Never assemble the lamp whilst unfocused or
feeling unwell.
Start-up
Mounting the light
Note:
We recommend assembling this light with
2 persons. When assembling the lamp base and
the lower gooseneck lamp unit
3
, be sure not to
damage the power cord inside the light. Remove all
packaging material. You will also need a cross-tip
screwdriver.
Place the lamp base with the lower gooseneck
lamp unit
3
on the floor in front of you.
Carefully lift the aluminium baffle
1
approx.
30 cm out of the guide for the lower gooseneck
lamp unit. This will expose 4 bores.
Position these bores congruent over the assembly
bracket for the lower gooseneck lamp unit
4
.
Note:
The internal power cord
2 b
must simul-
taneously be pushed into the lower gooseneck
lamp unit. Choose the ideal angle between the
power cord and the lower gooseneck lamp unit
when doing so. Hold the lower gooseneck lamp