20 GB/IE
Color changing mode
FLASH:
Press the FLASH button
8
to
select a colour change pattern alternating
between the basic colours red, green and
blue (RGB).
STROBE:
Press the STROBE button
9
to
select a sophisticated colour changing
program:
- white light flashes 6 times, then ...
- RGB light colours alternate with a “rough“
transition, then ...
- 7-colour change with a “rough“ transition,
then ...
- RGB light colours change with a “soft“
transition, then ...
- 7-colour change with a “soft“ transition.
FADE:
Press the FADE button
10
to gener-
ate a colour change between 7 colours and
a “soft“ transition.
SMOOTH:
Press the SMOOTH button
11
to generate a colour change between
7 colours and a “soft and slow“ transition.
Repeatedly press the button
3
to gradu-
ally increase the color changing speed.
Repeatedly press the button
4
to grad-
ually reduce the color changing speed.
There are 5 speeds level.
Switching off
When switching the lamp
1
off, using the
OFF button
5
on the remote control
2
.
When switching the lamp
1
on, using the
ON button
6
, the last colour or the last se-
lected colour changing mode will be resumed.
However, if the power supply of the lamp
1
was disconnected, for example, switch off
by electrical / mechanical switch, or take
out the lamp
1
from the lamp socket, etc.
Then, even the power resume and the lamp
1
light up again, it will only light up in
white color at medium bright level.
Changing the battery
Change the battery
16
when the range of
the remote control
2
noticeably decreases
or the lamp
1
no longer responds to the
remote control
2
being operated.
To do so, proceed as shown in Figure B.
Only use a battery type CR2025 and note
the correct polarity when inserting the
battery. This is shown on the back of the
remote control
2
.
