LIVARNO LUX 311798, Operation And Safety Notes

Page: 37 / 50

37 GB/MT
Preparing for use
Installing the product
Install the product in accordance with Figures A, C, D:
1. Rotate the solar cell housing
1
anticlockwise out of the
lamp shade
2
(see Fig. A).
2. Move the ON / OFF switch
5
into the ON position to
switch the light on.
3. Insert the solar cell housing
1
into the lamp shade
2
and
tighten by turning it clockwise.
4. Place the light on to the pole
3
.
5. Take out the ground stake
4
from the pole
3
and insert
it into the pole
3
with the tip facing downwards (see
Fig. C).
6. Your product is ready for use (see Fig. D).
Setting up the product
Insert the assembled product far enough into the ground
(lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance at all
times. Do not use any force when assembling or setting-up
the product, e.g. hammer blows. This will damage the
product. In order to achieve the best result, set the product
up in a place where the solar cell will get direct sunlight
for as long as possible.
Make sure that the solar cell is not influenced by any
other source of light such as yard or street lighting as
otherwise the light will not come on in twilight.
The light automatically switches on in twilight conditions
and off again when normal outdoor lighting conditions
return.
Replacing the rechargeable battery
The battery should be replaced every 12 months to ensure
optimum performance.
1. Separate the solar cell housing
1
from the lamp shade
2
by moving it anti-clockwise (see Fig. A). Switch off the
light with the ON- / OFF-switch
5
.
2. Loosen the fastening screws
6
by using a small cross
head screwdriver and then lever out the battery compart-
ment lid
7
of the solar cell housing
1
with the help of a
slot screwdriver (see Fig. B).
3. Turn over the battery compartment lid
7
, take care not to
damage the cables and cable connections (see Fig. B).