8
GB
These rechargeable batteries store the electricity fed by the solar cell. Fully charged rechargeable
batteries will provide about 2 hours of light on the „PIR“ setting, and about 8 hours on „ECO“.
In summer completely drained rechargeable batteries take about 2 to 4 days to fully recharge in
constant sunlight. The rechargeable batteries must be charged prior to initial use (see „Charging
rechargeable
batteries“).
Before use
Charging the rechargeable batteries
Note:
The rechargeable batteries inside the light head
2
are fully charged at delivery. However,
they may already have lost charge during transport from the manufacturer to the retail location.
Therefore charge the rechargeable batteries prior to use. During summer, initial charging will take at
least one day in constant sunlight.
Set the switch
12
to the „OFF“ position.
Note:
In constant sunlight (depending on the season) drained rechargeable batteries should take
two to ten days to charge.
Note:
the built-in charging controller of the product prevents the rechargeable batteries from over-
charging.
Replace the rechargeable batteries if light output does not improve after charging (Fig. C).
Assembly
Select a suitable place for installation.
Ensure that the motion sensor
7
will not be functionally inhibited at the desired place of installa-
tion due to obstacles or constantly moving objects.
Ensure that the product is mounted in a place with direct sunlight.
Ensure that the product is not installed where there are strong temperature fluctuations, e.g. due
to heating devices.
Ensure that the product is installed far away from unnatural light sources and in southern direction.
Ensure that the supplied screws and wall plugs are suitable for the type of wall. If not, use other
suitable screws and wall plugs. The manufacturer is not responsible for improper use of wall
connections.
Mounting the product
Ensure that the product is placed with the light head
2
upwards. Do not install the product in
any other position.
Secure the product to a stable and solid surface according to the instruction in Fig. A
Note:
The enclosed mounting material is suitable for ordinary masonry construction. Other wall
substrates may require other fastening materials. Seek specialist advice when in doubt.
After mounting, check that the product is fitted securely.
Start-up
Note:
The solar cell
1
also works as a twilight sensor, while the motion sensor
7
only responds to
movement.
When selecting the setup location for the solar cell
1
be sure the solar cell, just as the twilight
sensor, are not affected by other light sources, e.g. street lighting.
