9
GB/IE/NI
Start-up / Maintenance and Cleaning / Disposal
Start-up
Installing the LED tape light
Note:
Ensure that the installation area is clean,
grease-free and dry. Otherwise the functionality of
the adhesive strip may be impaired.
Choose a suitable installation area (window
etc.). Remove the protective foil from the reverse
side of the LED strip
3
. Ensure when removing
the protective film that you do not peel away
the adhesive tape too. Stick the LED strip
3
with the adhesive strip onto the installation area
and press it on firmly.
Alternatively, secure the LED strip
3
using the
hangers (silicone rings
9
).
Mount the solar panel
1
to the tube
4
and
the ground stake
5
. Ensure during assembly
that the solar panel
1
is connected flush with
the tube
4
. Mount the plug-in connector
2
.
Push the solar panel
1
with the earth stake
5
into the ground.
Loosen the locking screw
6
.
Adjust the solar panel
1
to the desired position.
Re-tighten the locking screw
6
.
Your light is now ready to use.
Switching the LED strip on / off
Note:
The LED strip is only switchable when the
light has been switched on by the twilight sensor.
Press the power switch (ON / OFF)
7
on the
solar panel
1
to switch on the LED strip
3
.
You can choose between 7 different effects or
permanent lighting by pressing the MODE
button
8
on the solar panel
1
.
The solar module takes approx. 3–4 hours to
charge. When fully charged, the lighting time
is 10–12 hours.
The solar panel
1
contains a twilight sensor
which automatically switches the light on and
off again.
Press the power switch (ON / OFF)
7
to
switch off the LED strip
3
.
Cutting the LED strip light
The LED strip light
3
can be cut to size as
required.
DANGER TO LIFE DUE TO
ELECTRIC SHOCK!
Disconnect the light from the power source be-
fore working on the LED strip light
3
.
Separate the LED strip
3
from the solar cell.
Determine the desired length for the LED strip
light
3
.
Note:
Make sure you cut the LED strip light
3
at the correct point (see Ill. B).
Cut the LED strip light
3
with a pair of scissors.
Be sure to cover the open end of the LED strip
light
3
with the adhesive strip
10
before us-
ing the light (see Ill. C).
Maintenance and cleaning
DANGER TO LIFE FROM
ELECTRIC SHOCK!
Disconnect the light from the power supply through
the solar panel
1
before performing any work on
the LED strip
3
.
Disconnect the plug-in connector
2
to do so.
Do not use solvents, petrol or similar substances,
as they would damage the light.
Use a dry, lint-free cloth to clean the LED tap
light
3
.
Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
b
a
Observe the marking of the packaging
materials for waste separation, which
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
Safety
