48 GB/MT
during these 1.5 minutes, the light ON time will reset.
In this setting the LEDs will be fully powered. With the
batteries fully charged the charge on this setting will
provide light for a total of approx. 2 hours.
Maintenance / changing batteries
To ensure good solar cell
6
performance the solar cell must be cleaned
regularly (see „Cleaning and care“).
Change the batteries as follows:
Slide the switch
5
to the „OFF“ position.
Loosen the cover screws
11
the back of the main unit
1
using a
cross-tip screwdriver (see Fig. E).
Remove the back of the main unit.
Remove the batteries from the battery compartment
10
and replace
with new rechargeable batteries with the same technical data. Be sure
to insert the batteries in the correct direction. The correct polarity is
shown inside the battery compartment.
Close the back of the main unit and secure the cover screws.
Winter-time use
The low amount of sunlight may reduce the light ON time at night depend-
ing on the on-time. Due to the low position of the sun please also verify the
solar cell
6
is out of shade throughout the day in winter and remove ice
and snow as necessary.
If the light ON time is inadequate due to the weather, recharge or replace
the batteries (see„Charging the rechargeable
batteries“ or „changing batteries“).
Summary of Contents for 109613
Page 3: ...3 B C D 7 9 7 8 8 A 1 4 6 2 3 5 4 ...
Page 4: ...4 E F 10 11 ...
