47
GB/MT
material such as cable clamps or conduit to fasten the cable, to prevent
damage to the insulation.
Connect the plug connector
4
from the main unit cable and the solar
cell (see Fig. D).
Start-up
Note:
Connect the main station
1
to the solar cell
6
before using for the
first time. The solar cell
6
also works as a twilight sensor, while the
motion sensor
3
only responds to movement.
When selecting the setup location for the solar cell
6
be sure the
solar cell, just as the twilight sensor, are not affected by other light
sources, e.g. street lighting.
The switch
5
on the main unit
1
(Fig. A) features the following functions:
Position „OFF“:
Sensor
3
and spotlight
2
are off. In direct sunlight
the rechargeable batteries are charged by the solar
cell
6
. Use this setting to charge drained batteries
(see „Charging the rechargeable
batteries“).
Position „AUTO“: The spotlight automatically switches on or off once
the solar cell
6
detects dusk or dawn. To ensure a
long life the LEDs will not be fully powered in this set-
ting, but only provide approx. 25 % of their full light
power (eco mode). When fully charged, the
batteries will provide approx. 8 hours of light in this
setting.
Position „PIR“:
The solar cell charges the batteries in sunlight. The
solar cell
6
automatically switches the spotlight on
in twilight or the dark when the motion sensor
3
detects movement. The light ON time is preset to ap-
prox. 1.5 minutes. If additional movement is detected
Summary of Contents for 109613
Page 3: ...3 B C D 7 9 7 8 8 A 1 4 6 2 3 5 4 ...
Page 4: ...4 E F 10 11 ...
