INSTALLATION INSTRUCTIONS for Lithonia Lighting EU2C Models
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
LED DUAL HEAD EMERGENCY LIGHTING FIXTURE
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING:
FAILURE TO FOLLOW THESE INSTRUCTIONS
AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY OR
SIGNIFICANT PROPERTY DAMAGE. For your protection, read and
follow these warnings and instructions carefully before installing or
maintaining this equipment. These instructions do not attempt to cover
all installation and maintenance situations. If you do not understand
these instructions or additional information is required, contact
LITHONIA LIGHTING or your local LITHONIA LIGHTING distributor.
WARNING:
RISK OF ELECTRIC SHOCK - NEVER CONNECT
TO, DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT IS
ENERGIZED.
WARNING:
RISK OF FIRE. Lamps are hot. Keep combustible material away from hot parts. Observe lamp manufacturer’s warnings,
recommendations and restrictions on lamp operation and maintenance. Make sure lamps are correctly installed.
CAUTION:
The battery in this unit may not be fully charged. After electricity is connected to unit, let battery charge for at least 24
hours, then normal operation of this unit should take effect. To check, press the TEST button. The lamps on the unit should turn on.
IMPORTANT SAFEGUARDS:
When using electrical equipment, basic safety precautions should
always be followed, including the following:
PAGE: 1 of
4
Fig.A (J-Box)
Fig.B
Fig.C
BATTERY CONNECTOR
PLUG IN
NOTE
:
Complies
with California Title 20
. P
roduct label is marked with
.
INSTALLATION:
NOTE:
Max mounting height
is
10
ft to achieve at least 1 ft-candle of illuminance in emergency
mode.
•
Do not use outdoors.
•
Consult local building code for approved wiring and installation.
•
Disconnect AC power before servicing and installation.
•
Do not mount near gas or electric heaters.
•
Do not use this equipment for anything other than its intended use.
•
The use of accessory equipment not recommended by the manufacturer will void product listing and warranty and may cause an unsafe condition.
•
Any service on this equipment should be performed
by
qualified personnel only.
•
Equipment should be mounted in locations and at heights where it will not be subject to tampering by unauthorized personnel.
•
Do not ceiling mount.
•
Use caution when servicing batteries.
•
Cap unused wires with enclosed wire nuts or other approved method.
•
Make sure wire terminations are secure and leads are properly tucked in appropriate wire channels.