INSTALLATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
PAGE: 3 of 4
A. Normal Operation:
When the unit is functioning properly, with power applied, the “TEST” switch will be illuminated red.
B. To Test:
Press the “TEST” switch. The fi xture will remain illuminated. When switch is released, the lamps will go off.
NOTE:
See important battery information before testing.
INSTALLATION & MAINTENANCE
To Open Housing:
Press both circular snaps at the bottom of the hous-
ing. Lift the housing upward and pull it fi rmly away
from the mounting plate.
Lamp Replacement:
Disconnect the wire harness for the LED lamp board.
Unscrew the screws holding the LED lamp board to
the refl ector. Re-attach the new LED lamp board onto
the refl ector and connect the connector.
Charger Board Replacement:
Flex the snap at each end of charger board and pull
it straight out of the housing. Disconnect lamphead
wires from board and reconnect them to new board.
Slide charger board into place, make sure it is se-
cured by the snaps on both ends.
Lens Removal:
Using small straight blade tool, gently remove
the lens from the lamp head as shown above.
Battery Replacement:
Disconnect battery connector. Cut cable tie
and remove battery. Install new battery in
orientation as shown above. Reconnect battery
connector.
IMPORTANT BATTERY INFORMATION:
Allow battery to charge for 24 hours
before testing and fi rst use. Batteries
are perishable items. For best results,
it is recommended that the battery
receive an initial charge within the fi rst
3 years of the manufacture date of the
fi xture. The manufacture date can be
found on the outside of the unit pack-
aging and on the UL label as part of
the Date Code/Series.
Snaps
TEST
switch