To use PoE Bolt on device with the WiFi PRO speaker you shall need an PoE
injector to deliver miniumum of 60W power via IEEE 802.3af/at/bt standard.
1.
To power the WiFi PRO speaker via PoE power, you must remove the DC connector which
is powered by the mains from the speaker.
2.
Connect the PoE injector via ethernet cable into the RJ45 port on the PoE bolt on (Ensure a
click noise)
3 .
Connect the DC cable connector from the PoE bolt on into the speaker.
4.
Line up the PoE bolt on with the rear of the PRO speaker and clip in place.
5.
If required clip the cable into the cable guides to ensure no snags occur for a tidy install
6.
You are all set. Turn the injector on and wait for a few seconds for the power to boot up.
POE SETUP
(OPTIONAL EXTRA)
1.
Remove the 2 screws from
the WiSA cover on the speaker
and remove the cover
2.
Slot the WiSA module into the speaker
dock and using the screws provided fix the
WiSA module to the upstands
WiSA
(OPTIONAL EXTRA)
If you have purchased the additional WiSA module please follow the steps below to fit into the
PRO WiFI speaker
ENSURE THE SPEAKER IS NOT CONNECTED TO THE POWER SUPPLY WHILST
INSTALLING
NOTE: When assembling the WiSA module try to avoid touching the pcba, use the non static
packaging to hold and put in place.
3.
Reassembled the cover and fix
screws in place and your all set.
4.
Open the WiSa Setting on your compatible
TV or projector to setup speakers.
A
B
B
B
A
B
B
B
A
B
B
B
A
B
B
B
A
B
B
B
A
B
B
B
12
