14
AUTOMATED LEARNING PROCESS/ACTIVATING CODE
Remove battery cover from back side of remote
control transmitter (I).
Install the 12-volt battery (K) and then replace
battery cover on remote control transmitter (I).
1.
(back side)
CAUTION:
The remote control transmitter (I) can be programmed to multiple receivers or fans. If
this is
not
desired, turn wall switch off to any other programmable receiver or fan.
1
Code Switches
Battery
Cover
I
K
2.
2
Align hole on the inside of the fitter plate cover
(U) with the threaded rod on the fitter plate (T).
Secure fitter plate cover (U) by turning fitter plate
cover (U) clockwise until it no longer turns.
U
T
Threaded
Rod
Assembly is now complete.
INSTALLING FAN WITHOUT LIGHT KIT
2. Restore electrical power. Within 30 seconds of
restoring electrical power, press the “OFF” button
on the front of the remote control transmitter (I)
for 5 seconds or until light on fan blinks twice.
Use the remote control to test the oscillation, fan
and light functions (see operating instructions
below) to confirm the learning process is
complete.
IMPORTANT:
To prevent damage to remote
control transmitter (I), remove the battery (K) if
not used for long periods. Store the remote
control transmitter (I) away from excess heat.
2
(front)
I
