nodule
page 7
9. Automated Learning Process./
Activating Code.
CAUTION
:
The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover from back side of remote
control transmitter.
Install one 9-volt battery (sold separately) in
transmitter.
Note:
Leave battery connected but
outside
of battery compartment until learning
process is complete.
Note
: The dimmer switch (labeled
ON/OFF
and
DIM
) has been pre-set to the "ON" position
(
DIM
). If you do not wish to have dimming
capability, please move the switch to the "OFF"
position (
ON/OFF
).
Restore electrical power. Within 30 seconds of
restoring electrical power, press the
LEARN
button, located on right-hand side at top of the
battery compartment, for 5 seconds or until fan
switches to MEDIUM speed. Test the light and fan
functions to confirm the learning process is
complete--see Section 11.
Place battery in battery compartment and then
replace battery cover on transmitter.
LOW MED HIGH
9V
ON/OFF
ON/OFF
battery
cover
LCD readout
light button
fan button
DIMMER
SWITCH
LEARN
BUTTON
TRANSMITTER
(
back
)
TRANSMITTER
(
front
)
glass shade
8. Light Kit Assembly.
Install one 100-watt max. halogen bulb, type JD
E11 (included).
Tip
:
Do not touch glass portion of bulb with fingers
or hands. Oil from skin can cause bulb to overheat
and go out prematurely. Use cardboard box or
foam wrapping bulb was packed with to layer
around glass portion of bulb.
Align slots on glass shade with nodules on fitter
plate (located on underside of motor housing).
Gently push up on glass shade and turn
to the
RIGHT (clockwise)
until it slides completely into
place.
IMPORTANT
:
The glass shade must be removed
in order to replace the bulb. When you need to
replace the bulb, please allow bulb and glass
shade to cool down before touching.
bulb
fitter plate
