page 7
10. Light Kit Assembly (Optional). (cont.)
If necessary, pull pre-cut section of plastic
covering off wire ends. Connect
WHITE
wire from switch housing to
WHITE
wire
from light kit fitter. Connect
BLUE
wire
from switch housing to
BLACK
wire from
light kit fitter. Use wire nuts when making
the connections.
* Wrap each wire nut separately with
electrical tape as an extra safety measure.
Attach light kit fitter to switch housing with
3 screws that were previously removed.
Tighten with Phillips screwdriver.
Secure the 3 glass shades using thumb
screws provided in one of the hardware
packs.
Do not overtighten thumb screws as
glass may crack or break.
Install 3 candelabra base 60 watt max.
bulbs (sold separately), size A15C
recommended.
Important
: When replacing bulbs, please
allow bulb(s) and glass shade(s) to cool
down before touching them.
11. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and wall switch (if applicable). Test
fan speeds with pull chain on switch housing.
Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third
pull will set the fan to LOW. Fourth pull will
re-set the fan to the OFF setting. Test the lights
with the pull chain in the middle. If fan and/or
lights does/do not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off when moving the
reverse switch. Set reverse switch to
recirculate air depending on the season.
Attach pull chain extensions supplied or
custom pull chain extensions (sold separately)
to the ends of the pull chains.
motor housing
black wire
blue
wire
white
wire
white wire
glass shade
bulb, size A15C
*
light kit
fitter
reverse
switch
pull chain
extension
pull chain
extension
thumb
screws
thumb
screw
switch
housing
