USER GUIDE
VP-3103-111U
10kW VPOC™ Power System
VP-3103-111U-UG-03
Page 12 of 23
3.
Pull out the locking handle of the VPOC™ Power Module (see
❶
below) and insert the module
into the left-most slot labeled PWR MODULE as shown below. Put your thumb under the locking
handle when pushing it in; as module engages the chassis, the locking handle will move up slightly.
4.
Complete module installation by pushing up the locking handle until it locks into place into the
chassis.
5.
Connect cable from the front bezel to the VPOC™ Power Module (see
❶
below) until it latches
into place. Note: You must press down this latch to separate this connector when removing the
Power Module from the bezel.
