How To Sync
1/ Make sure the model is turned Off and locate a flat level surface.
2/ Plug the battery into the SNAP, close the battery hatch and turn it on. Place the SNAP
on the flat surface, you must do this within 5 seconds of turning the power switch ON.
You will see flashing lights on the SNAP start to blink.
3/ Turn on the power for the controller. You will see a flashing red LED light and audible
beep indicating the power is on.
4/ Move the left control stick (this is also the throttle stick) all the way up, then all the
way down. In a few seconds the blinking LED on the SNAP and the blinking LED on the
controller will both be solid. The model is now bound.
The SNAP MUST be on a flat surface in order to digitally self level itself, otherwise the
model will not sync to the controller.
During charging:
- It is normal for the battery to get warm during the charging process. Do not charge
the battery on a surface that is flammable or can be damaged by heat.
- Do not leave the battery and charger unattended while charging.
- After charging, unplug charger from model.
- Do not store the model plugged into the charger.
2/ Plug the USB into your computer, TV, or USB charger. The
LED light on the USB will turn RED.
2/ Plug the other end of the cable into your Litehawk SNAP
battery. Do not force the plug, it only goes in one way. The
LED light on the USB will turn OFF.
3/ Charge time can take up to 60 minute (shorter if charging
for the first time). Once charged the LED light on the USB will
turn back on to RED.
Tip: If storing for more than 24 hours it is best to store with
a fully charged battery. Failure to do so can damage the
battery pack and shorten its useful life.
- Always remove the battery from the toy for charging.
- Unplug the battery from the toy if storing for more than 24
hours.
LiteHawk SNAP Instruction Manual
7
www.litehawk.ca
R
