EN
Page 22
Page 23
damages.
Store clipper and accessories on the following conditions:
•
Always store in the provided case.
•
Do not store outdoor.
•
Store dry and dust-free.
•
Protect against solar irradiation.
•
Avoid mechanical shocks.
•
Storage temperature: 0 until 40°C.
•
Relative humidity: max. 75 %.
•
When storing longer than 3 months, check periodically the general condition of
all parts. If necessary, refresh or renew the conservation.
6.
Operation
Incorrect operation may cause damage on persons or objects. Therefore:
•
Do all the steps of operation according to the indications in this instruction
manual.
6.1.
Initial start-up
6.1.1.
Setting up of the charging station
•
Observe all technical data according to the operating conditions (3 Technical Data).
•
The installation surface must be even and must dispose of sufficient stability and payload.
•
The location of installation must be protected against humidity and rain.
•
Power outlets in the outer area must be equipped with a residual current circuit breaker
(FI).
•
The workplace must dispose of sufficient illumination and ventilation.
•
The location of installation must be out of reach of children.
1. Place the charging station on a firm,
even, dry, clean and free underground.
2. Plug the charging station in the power
outlet.
3. The permanent light of the green LED
signalises, that the plug is connected
correctly to the power outlet and the
charging station is ready for use.
6.1.2.
Charging the batteries
1. Test the contacts of the clipper (1) and
the battery (2) for foreign particles and
contamination.
2. Assure, that the switch of the clipper is in
OFF-position ("0") (fig. 4).
