EN
Page 20
Have the motor replaced
Runtime on a single charge
is too short and / or blades
are hot.
Blades were not lubricated
enough
Oil Blades
Empty, not fully charged, or
faulty batteries were used
Use intact, fully loaded origi-
nal batteries.
Shearing tension too high
clipping
Do not tighten pressure tensi-
on nut so much.
If the blades still do not cut,
they should be resharpened
or
replaced
Green or red LED on the
charging station is not lit.
Charging station is not
connected to the power
supply.
Connect charger to power
supply.
Electronic unit defective
Have it repaired by service
centre
An inserted empty battery
the normal charging does
not start.
Contacts of the battery and /
or charger are dirty.
Clean contacts
Battery is defective
Replace battery
Electronic unit defective
Have it repaired by service
centre
Red LED flashes
Battery defective
Replace battery
Akku ist defekt
Akku ersetzen
6.
Others
6.1.
Environmental Protection and Disposal
The owner has a duty to dispose of the clipper blades as well as of the clipping machine proper-
ly at the end of its service life. Please observe your relevant national regulations.
6.2.
Declaration of conformity
This device complies with the requirements of the following EU directives:
2004/108/EG
2006/95/EG
