Listen SoundConnect 2, User Manual

Page: 12 / 27

6 Introduction SoundConnect 2
TM
Manual
Setup Button
This activates a menu on the front panel display allowing
you to access secondary parameters not available when the
Channel buttons or Gain buttons are pressed.

Parameters are displayed on the top display row;
values on the bottom.

Except for the Gain menu, Parameter and Value
menus are cyclical; after the last value is displayed,
the selections are repeated from the top of the order.

The setup menu is exited when you press the Setup
button again. The display will revert to the Channel Settings Mode after 30 seconds.
Setup Mode 1 - Channel

Pressing the Setup Button once activates Setup Mode 1

The unit parameter is displayed on the top row, and the respective value is displayed on the bottom
row

Pressing the Channel button changes the Parameter field for that channel

Pressing the Gain button changes the value for that parameter
Parameters specific to Channel 1 and Channel 2 are selected, in the following order:
1. High Pass Filters:
a Displayed Parameter = HPF
b Displayed Values = 1 Hz, 10 Hz, 20 Hz, 100 Hz
2. Low Pass Filter:
a Displayed Parameter = LPF
b Displayed Values = 22.4 kHz, 120 kHz
3. Constant Voltage (SCM) Feed Resistance:
a Displayed Parameter = SCM Res
b Displayed Values = No Bias, 7.5 kOhm (for SCM mics), 2.2 kOhm (typically used for testing
electret capsules). Factory calibrated for 10 VDC open circuit using 7.5 kOhm setting.
4. Constant Current (IEPE) Current:
a Displayed Parameter = IEPE
b Displayed Values = 10 mA, 4 mA, No Bias
5. Polarization Voltage:
(This option is only displayed when the optional Lemo board is installed.)
a Displayed Parameter = Pol
b Displayed Values = +200 VDC
Values are applied immediately after a button is pressed.
HPF
1 Hz 1 Hz
HPF
Parameters
Values