Lissmac DTS 401, Operating Instructions Manual

Page: 29 / 44

29/44
5.3. Cutting with the table saw
CAUTION
Cutting with insufficient cooling
Saw blade will overheat and cutting segments may break off
 Always cut with sufficient water
NOTICE
Cutting with insufficient cooling
Damage to saw blade due to lack of cooling water

Dry cutting without water is prohibited
Sequence
• Check Height settings of saw blade (clearance of sawing table)
•
Place workpiece on the sawing table
•
Switch on table saw on the ON switch
• Set the water volume via the control valve on the saw blade guard
• After reaching the full speed, the sawing table with the workpiece can slowly be pushed against the
saw blade
NOTICE
Strongly polluted water reduces the life of the pump and the saw blade

During frequent use, change water several times a day and remove saw slurry.

Clean suction strainer of the pump with every water change.