15
5.
Operation
5.1
Placing of the saw
•
The work place should be sufficiently illuminated.
•
Place the saw on clean and solid, stable ground.
•
Check if the saw is standing stable.
5.2
Preparation of cut-off operations (see 3.4)
5.3
Check sense of rotation of saw blade (see 3.5)
5.4
Change sense of rotation (see 3.6)
5.5
Cutting (see 3.7)
5.6
Cutting quality of the saw blade
Should the saw blade loose its cutting quality after a longer operation term, some cuts into
lime clay bricks or some similar material will "regrind" the blade.
5.7
Cooling water
Strongly polluted water reduces the lifetime of pump and saw blade.
•
When used frequently, replace water daily and remove the slurry, too.
•
Clean the suction sieve of the pump each time when replacing the water.
5.8
Height adjustment
Height adjustment is needed:
•
to cut bricks with a height of more than 270 mm by means of reversing cut.
Handling of height adjustment.
•
Motor is switched off.
•
Loosen the clamping lever (Pos. 7).
•
Adjust saw head to the desired height.
•
Tighten the clamping lever (Pos. 7).
5.9
Replacement of saw blade (see 3.3)
Summary of Contents for DTS 271
Page 11: ...11 2 5 Vibration at the handle Total value of vibration is under the action value of 2 5 m s2...
Page 13: ...13...
Page 16: ...16...
Page 22: ...22...
