Rev: 06.09.20
Page 4
CCD-0002734
The "WARNING" symbol above is a sign that a procedure has a safety risk involved and may cause
death, serious personal injury, severe product and/or property damage if not performed safely and
within the parameters set forth in this manual.
Failure to follow instructions provided in this manual may result in death, serious personal injury
and/or severe product and property damage, including voiding of the component warranty.
Unit MUST be supported per manufacturer's recommendations before working underneath. Failure
to do so may result in death or serious personal injury.
Always wear eye protection when performing service, maintenance or installation procedures.
Other safety equipment to consider would be hearing protection, gloves and possibly a full face
shield, depending on the nature of the task.
Moving parts can pinch, crush or cut. Keep clear and use caution.
Safety
Read and understand all instructions before installing or operating this product. Adhere to all safety labels.
This manual provides general instructions. Many variables can change the circumstances of the instructions,
e.g., the degree of difficulty, operation and ability of the individual performing the instructions. This
manual cannot begin to plot out instructions for every possibility, but provides the general instructions,
as necessary, for effectively interfacing with the device, product or system. Failure to correctly follow the
provided instructions may result in death, serious personal injury, severe product and/or property damage,
including voiding of the LCI limited warranty.
Preparation
Identify the location of the Repeater (Fig. 2A) and Repeater Dock (Fig. 2B), then gain access to the Repeater.
Pairing Alert Indicator to Repeater
1.
Pair the Alert Indicator (Fig. 3) to the Repeater (Fig. 2A) by pressing and releasing the Alert Indicator
button (Fig. 3A).
A.
The Indicator will power up and its Status LED (Fig. 3B) will blink red once and then blue three
times indicating the Alert Indicator is not linked to the Repeater.
NOTE:
After 10 seconds, the Indicator will enter sleep mode.
2.
Link the Alert Indicator to the Repeater by pressing and holding the Pair Mode button (Fig. 2D) on the
Repeater for at least five seconds, until the Status LED blinks rapidly.
3.
Release the Repeater’s Pair Mode button.
4.
Press the Alert Indicator's button (Fig. 3A) once to make sure the indicator is awake.
5.
Within 10 seconds of waking the indicator, press and hold the Alert Indicator button.
A.
Continue to hold the Alert Indicator button until its LED and buzzer sounds.
I.
One beep will sound off and one green LED flash will be emitted.
Continue to hold
the button
.
