Rev: 09.23.2016
Page 5
Standalone Smart Jack OEM Install Manual
Operation
NOTE:
The hitch height
MUST
be set in the memory prior to the normal operation of the Smart Jack.
Failure to do so will cause the Smart Jack and the trailer to not function as intended.
NOTE:
To cancel an action, press either the up arrow or down arrow. The action in process will stop.
Setting Hitch Height Memory
1.
Press and hold the up arrow (Fig.5A) and down arrow (Fig. 5B) at the same time for a minimum of 5
seconds to store the vertical position of the Smart Jack.
2.
The battery indicator lights (Fig. 5C) will all flash 5 times to show that the new position is successfully
stored in memory.
Normal Operation
1.
Press and hold the up arrow (Fig.5A) to extend the Smart Jack.
2.
Press and hold the down arrow (Fig. 5B) to retract the Smart Jack.
Auto Retract
NOTE:
This function should only be utilized once the tow vehicle has been reconnected and secured to the
trailer, prior to travel.
1.
Press the down arrow 3 times. On the 3rd time, hold the down arrow for 3-5 seconds. The jack will then
begin auto retracting from the hitch height into the fully-stowed position for travel.
Return To Hitch Height Operation
1.
Press and release both the up arrow (Fig.5A) and the down arrow (Fig. 5B) simultaneously 3 times
within 2 seconds.
2.
The jack will automatically retract or extend to the original hitch height position.
NOTE:
Visual indication that the jack is actuating to the hitch height is seen through the oscillation of the
battery LED indicator: i.e. lights will illuminate left to right, and then right to left. This will continue
until level.
Fig. 5
C
A
B
