7
574-537-8900
Rev: 08.31.20
CCD-0002641
Solera
®
Slide Topper
with Access Plates
Installation and Owner’s Manual
(For Aftermarket Applications)
Fig.12
6.
Feed one of the extension rods
(Fig.15A)
into an access
bracket
(Fig.15B)
. By pulling the extension rod all the way
into the access bracket, the opposite end extension rod
can now slide into the access bracket at the opposite end.
NOTE:
If needed, the access brackets can slide left
or right to assist in getting both extension rods into the
access brackets.
Fig.13
B
A
Fig.14
UNROLLING THE FABRIC MORE THAN ONE TURN
WILL CAUSE THE SLIDE TOPPER TO LOSE TENSION
AND CREATE SLACK WHEN CLOSING THE SLIDE
ROOM. MAKE SURE TO LEAVE THE SLIDE ROOM
CLOSED OR NOT TO EXTEND MORE THAN 6”.
Installing the Solera Slide Topper Assembly
1.
To prepare for fabric installation, use a screwdriver
to spread open either end of the awning rail on the
installation end
(Fig.13A).
2.
To protect the fabric from damage during installation,
file any sharp edges or burrs from the awning rail.
3.
Spray the inside of the awning rail channel with silicone
lubricant
(Fig.13B)
.
4.
Remove packaging from the roll tube and unroll a small
portion of fabric, no more than one turn.
5.
Using at least two people, feed the polycord
(Fig.14A)
on
the fabric through the awning rail channel
(Fig.14B)
.
fabric
A
B
B
A
A
access
plate
access bracket
Fig.15
