Rev: 02.05.21
Page 3
CCD-0001448
Safety
Compatability
The HVAC control unit is compatible with the following appliances:
1.
Single-stage LP gas furnaces with self-contained fan control.
2.
Conventional air conditioning units with one or two-speed fans.
3.
Combination air conditioning/heat pump units with one or two-speed fans.
Switch Function
When "OFF"
When "ON"
Note
Dual Speed Fan
Fan is High-speed only
Fan has a Low Speed wire
Heat Pump (HP)
Unit (if present) is AC only
Rooftop AC Unit includes HP
Orange wire
AC Unit Present
No AC unit in this zone
This zone has AC
HP setting ignored
Furnace Present
No furnace in this zone
This zone has gas furnace
Furnace has own fan
Specifications
Min
Typical
Max
Units
Operating Supply Voltage
9
13.8
18
Volts DC
Operating Temperature Range
14 (-10)
113 (+45)
°F (°C)
Quiescent Current
30
45
mA DC
Sink Current (Generator)
1.2
2.0
A DC
Focused Relay Drive Current
1.5
A DC
This HVAC control device requires 12V direct current (DC) and cannot operate from alternating
current (AC) sources. Do NOT connect the HVAC control device to AC power. Connecting the module
to AC will cause irreparable damage, and void the warranty.
Specifications
The HVAC control unit includes a "capabilities" switch which must be set to correspond with the attached
equipment. The switch settings are as follows:
HVAC Operation - OneControl
®
Touch Panel
NOTE:
When using the OneControl® HVAC system, all of the controls you would normally find on your
thermostat will be in the HVAC app on your OneControl® Touch Panel.
Power On/Off
1.
The device can be powered on or off using the button on the front of the device (Fig.1A).
NOTE:
It will take a few moments to start up and load the system.
2.
To enter or exit sleep mode, press and release the power button (Fig. 1A).
