Rev: 10.04.18
Page 1
CCD-0002267
TI-273
KWIKEE
®
REVOLUTION SERIES
STEP MOTOR REPLACEMENT INSTRUCTIONS (82-ST0502)
STEPS
Purpose
This document describes the removal and replacement of the Kwikee® Revolution Series step motor.
Note:
This information was obtained from Kwikee manual #82-ST0502 Rev 0B dated July 2013.
Required Resources
• Standard automotive style jack
or jack stand
•
5/16
" hex driver
•
5/16
" torque wrench
•
5/16
" socket with ratchet
Instructions
Steps MUSt be supported with the proper automotive style jack or jack stand that is in good working
order. If the step is not supported when the motor is removed, the step will open. Failure to properly
support the steps may result in death, serious personal injury or severe product damage.
Read and understand all of the following instructions before beginning this procedure.
Note:
This procedure must be completed with the steps either in the full retracted position or completely
removed from the coach.
1.
Using a standard automotive type jack or jack stand, brace the steps in the completely retracted
position (Fig. 1). This will prevent the steps from opening when the motor is removed from the step.
2.
Position the standard automotive type jack or jack stand to the rear of the steps. Leave some space
between the step frame and the jack or jack stand to allow for later adjustment when installing the
motor (Fig. 2).
Fig. 1
Fig. 2
Replacement Kit #380073
Part #
Description
369340
Motor for TT Revolution
369091
Hex Bolt,
5/16"
x 2"
360212
Plastic Spacer
