Rev: 10.24.19
Page 7
CCD-0002685
Solera Serenity LED Lights Installation - Optional
The Solera Serenity LED Lights (Fig. 9A) come pre-installed on specifically-fitted support arms. Installation
also requires the proper fabric with an LED wire welded into the fabric at the base. The Edge Awning with
Serenity must be installed prior to wiring the Solera Serenity LED lights.
Fig. 10
1.
Wire the LED wires on the idler arm to the wire welded into the awning fabric.
2.
Connect the other end of the wire welded into the fabric to the drive arm Serenity LED wire and
connect both to the power source.
3.
A 3 amp fuse that meets or exceeds RVIA standards
MUST
be installed in-line to protect the Serenity
LED lights wiring.
4.
Connect the LED power wire to the unit's power source. Make sure the black wire is connected to a
ground and the red wire is connected to a positive 12V DC power source.
Seal Wall Penetrations
1.
Seal all fastener locations and wire penetrations with silicone sealant to protect against water intrusion (Fig. 10).
A
Fig. 9
