Rev: 11.19.20
Page 13
CCD-0002764
3.
Locate the belt mounting assembly (Fig. 20). Unscrew the nuts (Fig. 21C) and slide the belt plates
(Fig. 21B) off the belt bracket (Fig. 21A) and set aside. Do this for all four belt brackets.
Fig. 20
Fig. 21
4.
If installing on a unit with aluminum backing in the wall, use a minimum size of #10 x 1" self-drilling
screws. If installing on a unit with wood backing in the wall, use a minimum size of #10 x 1" wood
screws.
5.
Place the bottom side of the bed frame down on level supporting saw horses at the approximate fully
retracted position. Make sure the bed frame is level.
6.
With the bed frame supported and at the fully retracted position, measure from the desired belt
mounting bracket position to the bottom of the bed on both sides. The measurement from the bottom
of the belt mounting bracket (Fig. 22A) to the bottom of the bed frame (Fig. 22C) should be at a
minimum of 100 mm (3 15/32 in).
The maximum distance away from the bottom of the belt mounting bracket (Fig. 22A) on the wall to
the edge of the rail of the bed frame (Fig. 22D) is 50 mm (1 31/32 in).
7.
Mark the measured locations for the brackets.
NOTE:
A prefabricated jig may be used for a faster installation of the belt brackets.
Fig. 22
100 mm (3
15/32
in)
Minimum Distance
50 mm (1
31/32
in)
Minimum Distance
A
B
C
D
