Rev: 11.27.19
Page 3
CCD-0002710
Failure to follow instructions provided in this manual may result in death, serious personal injury
and/or severe product and property damage, including voiding of the component warranty.
Unit MUST be supported per manufacturer's recommendations before working underneath. Failure
to do so may result in death or serious personal injury.
Always wear eye protection when performing service, maintenance or installation procedures.
Other safety equipment to consider would be hearing protection, gloves and possibly a full face
shield, depending on the nature of the task.
Moving parts can pinch, crush or cut. Keep clear and use caution.
Resources Required
• Cordless or electric drill or screw gun
• Appropriate drive bits
•
3/8
" - 1
1/2
" full threaded bolts
•
3/8
" SAE flat washers
•
3/8
" nylon locking nut
•
3/16
" hex wrench (stop block set screw)
• #8 - 32 x 1" full threaded bolts
• #8 SAE flat washers
• #8 - 32 flange nuts
•
7/16
" wrench
•
9/16
" wrench
• 1
5/16
" wrench
• #8 x 1" self-tapping screws
•
1/2
" drill bit
• 1
3/8
" drill bit
• Jig saw or saws-all
• Heat gun (electrical connections)
• Crimp butt connectors
• Crimp tool
• Marking method
The “CAUTION” symbol above is a sign that a safety risk is involved and may cause personal injury
and/or product or property damage if not safely adhered to and within the parameters set forth
in this manual.
Preparation
1.
Make sure unit is parked on solid, level ground.
The unit MUST be supported per manufacturer's recommendations before working underneath.
Failure to do so may result in death, serious personal injury and/or severe product or
property damage.
2.
Make sure the unit is level and supported in accordance with manufacturer's recommendations.
3.
Inspect slide-out mechanism to make sure that all stop blocks are intact and that there are no missing/
damaged parts.