Operating
instructions
Weed
Extractor
WED
90/110/125/155
21 - 24
04.11.2004 / 01
11. Replacement of the brushes
To replace the brushes, raise the machine by means of the
supporting wheels as far as possible so that the brushes do no
longer touch the ground. Take out the brush holders towards the
bottom, after having removed the linch pins, and exchange brushes
outside the machine.
Attention! Never lie under the not-secured machine when
changing the brushes!
When replacing the lower plates, make sure that the lock nuts
engage firmly in the recesses, to prevent them from turning and
getting damaged when loosening or tightening the screws.
Note: Damaged screws should be replaced. (Only use original
screws!)
12. After use
If the LIPCO Weed Extractor is to remain unused for a longer period,
it is necessary to carry out the following steps:
•
Thoroughly wash and dry the Weed Extractor.
•
Thoroughly check the function of the moving parts, replace any
damaged, worn or deteriorated parts.
•
Check whether all screws are tightened.
•
Check the oil and lubricant levels.
•
Clean and lubricate the universal joint shaft.
•
Grease all unpainted metal parts to protect them against
corrosion, cover the
L
L
I
I
P
P
C
C
O
O
W
W
e
e
e
e
d
d
E
E
x
x
t
t
r
r
a
a
c
c
t
t
o
o
r
r
and store it in a dry
place so that it will be ready for use any time.
Attention! Before using the unit again, follow the
instructions in chapter "10. Maintenance"!