3
Figure 1. Switch locations
RUN
PGM
VOLUME KNOB
A
s your fleet of LEGACY or TMCC equipped locomotives and equipment grows, you will want to
assign each unit a unique ID#. Use your CAB-1, CAB-1L, or CAB-2 Remote Controller.
1. With track power off, place the Boom Car on the track.
2. Make sure that the Command Base is plugged in, then power up the track.
3. Lift off the roof and slide the RUN/PROGRAM switch to the PGM position.
4. Press ENG.
5. Enter the ID# for the Boom Car using the numeric keypad on the Remote Controller.
Select any number between 1 and 99.
Your Boom Car is factory programmed with an ENG ID# of 1.
For proper operation, be sure to assign the same ID# to the Boom Car and the
Crane Car.
6. Press SET.
7. Slide the RUN/PROGRAM switch to the RUN position and replace the roof.
At this point, the new ID# has been set. When you power up, be sure to address the Boom Car
using the new ID#.
Assigning a new ID to your Boom Car
Note
Note
