20
Installing a nine-volt alkaline battery
LEGACY RailSounds Sound System operations
A
lthough the LEGACY RailSounds sound system is powered through the track, we
recommend that you install a nine-volt alkaline battery in the tender to prevent the sound
system from shutting down during track power interruptions (for example, over a dirty section
of track). Follow these steps and refer to Figure 11 as you install the battery.
If the RailSounds sound system turns off during interruptions in track power, you
may need to replace the battery.
1. Remove the two body screws from the underside of the tender. Refer to Figure 11 for the
location of the screws.
2. Carefully lift the rear deck/coal load off the body. Be careful to avoid pulling on the wires
that connect the rear deck/coal load to the body.
3. Remove the protective cover from the battery harness.
4. Snap the battery harness onto the nine-volt alkaline battery’s terminals.
5. Slide the battery into the battery holder, which is attached to the frame.
6. Replace the rear deck/coal load and secure it with the body mounting screws. Be careful to
avoid pinching wires between the rear deck/coal load and the body.
To prevent damage to the body, do not overtighten the screws.
Note!
Note!
Figure 11. Installing the battery in the tender
Body screws
Battery harness
Battery holder
