- Make sure that the protective cover is clean, not
damaged and fits tightly to the floor.
If the protective cover is damaged, replace it with a new
one.
- When you shut the engine off, the bearing disc stops
spinning after a short time. Continue with grinding until the
grinding
head stops spinning completely. Before lifting the machine,
make sure the bearing disc stopped spinning.
- When grinding adhesive surfaces, such as asphalt, paints etc.,
after completed work slightly lift the front part of the machine
to prevent sticking to the floor because of the heated surfaces.
Before lifting the machine, make sure the bearing disc stopped
spinning.
- The temperature of removable discs after the operation can
be very high. Before removing them wait until the machine is
cool. Use protective gloves.
- Do not use the machine on the sand, stairs, walls, roof,
and
ceramic tiles.
- Do not use the machine, if it is exposed to precipitations.
- When using the machine, be careful not to hit the power
cord.
- Make sure no one is present at a distance of one meter in
front of the machine.
- In case of failure contact the company
Polirtlak d.o.o.,
Š
tihova ulica 10, 1000 Ljubljana,
Slovenia) to repair the
machine.
CABLES AND SOCKETS
The cable from the inverter to the electric motor: wire
diameter of 2,5 mm, quantity of wires in the cable 4.
Power cord: 2,5 mm, quantity of wires in the cable 3.
Sockets of 16 amps.
Type of sockets: ABB 316-P6 16
А
380-415 3P+1 IP44.
-14-
