Page 28 of 29
Copyright © 2010 Linn Products Ltd.
4.
Carefully lift out the drive unit and
disconnect the
YELLOW
banded grey
accelerometer cable from the connector.
Unsolder the red and black wires from the
drive unit.
Note: It may be advisable to protect the
cabinet from solder blobs or splashes while
using the soldering iron.
1.
Connect the
YELLOW
banded grey
accelerometer cable to the connector on the
drive unit.
Solder the red and black wires to the drive
unit in the correct position.
Note: It may be advisable to protect the
cabinet from solder blobs or splashes while
using the soldering iron.
2.
Carefully fit the speaker into position and
ensure all the mounting holes line-up correctly.
Insert and tighten all 6 screws and washers to
secure the drive unit.
Note: Check the mounting screws with the
torque tool set at 3.7Nm with the T25 Torx
bit fitted.
FITTING THE LOWER SERVO BASS DRIVE UNIT
