5.Befestigen Sie je zwei Schrauben auf jede Seite
6 . Montieren Sie die Schaufelräder auf der Welle (30mm Schraubenschlüssel
liegt bei)
7. Fertig und betriebsbereit
ATTENTION !
When floating the aerator in the water never submerge the motor! This motor is
not a submersible motor!!!
Beware of the rotating wheels !!
To avoid injury, please disconnect from the power supply before working on the
machine
Electrical Connection
The connection of the
AquaWheel
to an electrical supply should be made as with any
other water-circulating pump. It is essential to use an ELCB or RCD. Repair of the
electrical connection or motor (after the expiry of the manufacturer’s warranty) should
only be carried out by the manufacturer or a qualified electrician.
Installation
For economic packing and transport,
AquaWheel
is supplied in two parts (float and
complete motor housing). Assembly is very simple. Two tools are required, a 13mm
spanner, and the enclosed 30mm spanner.
a) Turn the float so that the large, single handle is at the front. Lift and rotate the
motor and cover so that the steep side of the cover faces forward. The main
paddle drive shaft will protrude from the cover from the left and right. The motor
assembly can slide on the float. Ensure that the holes in the float and motor
assembly locate in the rear position. Remove the motor cover, by loosening the
two screws at the front and rear of the cover. Remove the cover. Thread the
four 90mm screws through the holes, fit the washers, spring washers and nuts,
and tighten.
b) The impellers are enclosed loose. They only have to be fitted onto the shafts
ends. The unit with 0.55 kW has one wheel on each side, the unit with 1.1 kW
has two wheels on each side. Please note that the open sides of the blades
must always point to the front. Of course, the impellers should be mounted in the
same way. Using the 30 mm open-end wrench, you must tighten the nuts on the
impellers and thus fasten the impellers to the shaft. The unit is now fully
assembled and can be put into operation.
c) The 1.1 kW unit also contains a distance piece at the rear around the U-float.
This part must not be removed.
First Use
a) Two ropes will be needed to secure the
AquaWheel
in position. It is convenient
to fasten the middle of each of the two ropes to one of the holes at each front
corner of the float. Otherwise, use the handles if more convenient, ensuring that
the ropes or cable will not foul the rotating paddles when in use.
Float the aerator into position, and fasten the ends of each rope
(four fastening points) to form two “V”s. The anchors should be
at the water surface level.
Arrange the electrical supply cable carefully to prevent damage.
b) Check the direction of rotation. The direction of rotation can be changed by
swapping the wires at the live poles of the motor protection plug.
c) Do not damage the cable!
Maintenance
The
AquaWheel
is almost maintenance-free. The gear belt should be checked
periodically. To do this, loosen the two screws at the front and rear side of the motor
housing and remove the cover, then check the belt.
