E1400 V1 Rev. E Installation Guide
6.4 X2-V1 Rev. D/E
X2
Motor Phases
PE:
Protective Earth
W:
Motor Phase W
V:
Motor Phase V
U:
Motor Phase U
T+:
Temperature Sensor KTY+ (on DC- voltage level!)
T-:
Temperature Sensor KTY- (on DC- voltage level!)
The Shield of the motor cable has to be mounted with a surface as large as possible (low
ohm, low impedance). Use an EMC shield clamp for fixing.
Attention:
KTY+ and KTY- are not referenced to ground! They are on DC- voltage!
An isolated thermistor is necessary! Especially LinMot D01 and D02
Motors can not be connected!
Screw Terminals:
- Tightening torque: 0.7 - 0.8 Nm (6.2 – 7.0 lbin)
- Use a cross-head screw driver (PH1)
- Use 60/75°C copper conductors only
- Conductor cross-section: 0.25 – 4 mm
2
(depends on Motor current) / AWG 24 -12
- Stripping length 10mm
Attention:
The type of connector and pin assignment on V1 Rev. D and V2 drives
is different from V1 (Rev. A-C) drives (different coding)!
6.5 X31-X32
X31-X32
Motor Brake and Motor Brake Supply
X32:
Brake-
Brake+
X31:
Brake Supply GND
Brake 24VDC
Page 10/23
www.LinMot.com
NTI AG / LinMot
®
