Linksys WAG200G, Quick Installation Manual

Page: 89 / 158

19
Chapter 5: Configuring the Wireless-G ADSL Home Gateway
The Setup Tab
Wireless-G ADSL Home Gateway
The Advanced Routing Tab
The
Advanced Routing
screen allows you to configure the NAT, dynamic routing, and static routing settings.
Advanced Routing
• Operating Mode. In this section, you will configure the Gateway’s general routing settings.
• NAT. NAT is a security feature that is enabled by default. It enables the Gateway to translate IP addresses
of your local area network to a different IP address for the Internet. To disable NAT, click the Disabled
radio button.
• RIP. If you have multiple routers, you may want to use the Routing Information Protocol (RIP) so the routers
can exchange routing information with each other. To use RIP, select the Enabled radio button. Otherwise,
keep the default, Disabled .
• Send Default Route. To use RIP version 1 for routing, select the Enabled radio button. Otherwise, keep the
default, Disabled .
• Interface. This setting is available when you have configured a static route and you need to choose an
interface for that route. Select the interface that the Gateway will be using: LAN / Wireless or Internet .
• Dynamic Routing. With Dynamic Routing you can enable the Gateway to automatically adjust to physical
changes in the network’s layout. Using RIP, the Gateway determines the network packets’ route based on the
fewest number of hops between the source and the destination. The RIP protocol regularly broadcasts routing
information to other Gateways on the network.
• Transmit RIP Version. To transmit RIP messages, select the protocol you want: RIP1, RIP1-Compatible,
or RIP2 . If you don’t want to transmit RIP messages, select None .
• Receive RIP Version. To receive RIP messages, select the protocol you want: RIP1 or RIP2 . If you don’t
want to receive RIP messages, select None .
• Multicast or Broadcast. RIP can be sent using either methods. If you want to use multicasting, select
Multicast
. If you want to use Broadcast, select
Broadcast
.
• Static Routing. If the Gateway is connected to more than one network, it may be necessary to set up a static
route between them. A static route is a pre-determined pathway that network information must travel to
reach a specific host or network. To create a static route, change the following settings:
Figure 5-12: Advanced Routing