2
CHAPTER 1 Quick Start Guide
Linksys
Mounting Guide
To avoid overheating, do not install your access point if ambient temperatures
exceed 104°F (40°C) Install on a flat, stable surface, near the center of your
wireless coverage area making sure not to block vents on the sides of the device
enclosure
Wall Installation
1 Position drilling layout template at the desired location
2 Drill four screw holes on the mounting surface If your Ethernet cable is
routed behind the wall, mark Ethernet cable hole as well
3 Secure the mounting bracket on the wall with anchors and screws
4 If your Ethernet cable is routed behind the wall, cut or drill the Ethernet
cable hole you marked in Step 2 Feed the Ethernet cable through the hole
5 Connect the Ethernet cable and/or AC power adapter to your device
6 Slide the device into the bracket Turn clockwise until it locks into place
Ceiling Installation
1 Select ceiling tile for mounting and remove tile
2 Position drilling layout template at the desired location
3 Drill four screw holes and Ethernet cable hole on the surface of ceiling tile
4 Place back plate on the opposite side of ceiling tile Secure mounting
bracket to the ceiling tile with flathead screw and nut Route the Ethernet
cable through the Ethernet cable hole
5 Replace tile in ceiling
6 Connect the Ethernet cable and/or AC power adapter to your device
7 Slide the device into the bracket Turn access point clockwise until it locks
IMPORTANT
Improper or insecure mounting could result in damage to the device or personal
injury Linksys is not responsible for damages caused by improper mounting
