EtherFast
®
Layer 3 Management 4-Port Gigabit Ethernet Switch
IP Menu
The IP Menu, shown in Figure 6-34, is used to configure the IP subnets for
each VLAN on your Switch, the unicast and multicast routing protocols, and
IGMP.
• Subnet Configuration - Specifies the IP interface for VLANs configured on
this Switch, including the subnet address and routing protocols.
• Protocol Configuration - Enables the unicast and multicast routing proto-
cols globally for this Switch.
• Static ARP Configuration - Specifies the static Address Resolution
Protocol.
• Static Route - Configures a static route.
• Default Route - Defines the router to which this Switch will forward all traf-
fic for unknown networks.
Select OK to return to the previous panel.
44
Instant EtherFast
®
Series
• MEMBERS - Allows you to specify a port to a specific VLAN.
• UNTAG - Allows you to set traffic to be tagged or untagged per port.
Each port can be modified with the following character:
–
(Normal) Uses GVRP to determine port membership.
S
(Static) Adds port as a static entry. GVRP protocol is dis-
abled.
R
(Registration Fixed) Adds port as a static entry. GVRP
protocol messages are still forwarded through this port.
X
(Forbidden) Disables GVRP for this VLAN on the
specified port.
Select Apply to make changes. Select OK to return to the previous panel.
Select Prev Page to view the previous page. Select Next Page to view the next
page. To display a specific page, set the page number in the Page field and then
press Apply. Select Add to add a VLAN.
Reset Address Table Mode
The Reset Address Table Mode screen, shown in Figure 6-33, is used to
assign VLAN tables to existing VLANs.
• SVL - Specifies that all VLANs share one VLAN table.
• IVL - Specifies that each VLAN utilizes its own VLAN table.
43
Figure 6-33
Figure 6-34