Dual-Mode Internet Telephony Kit
14
Chapter 3: Getting Started
Getting Started with the Handset
Getting Started with the Handset
To insert the batteries and charge them, follow these instructions:
1. Remove the cover of the battery compartment.
2. Insert the two NiMH rechargeable, AAA batteries (included). Make sure the polarities are
correct. (The + and - ends of the batteries should be in the + and - slots of the compartment.)
3. Slide the cover upward until it snaps into place.
4. Plug the charger’s power adapter into an electrical outlet.
5. Place the handset on the charger. For the initial charge, let the batteries charge for 14 hours
before using the handset. This maximizes battery performance and life.
Proceed to the next section, “Getting Started with the USB Base Station.”
Figure 3-1: Handset’s
Batteries
NOTE:
The handset may become warm during the initial charge.
NOTE:
If the batteries are low, the handset may not power on for up to 15 minutes
and will emit a warning tone. Place the handset on the charger to recharge.
Figure 3-2: Handset on
Charger
Summary of Contents for CIT300
