Troubleshooting
Common Problems and Solutions
This section provides possible solutions to problems regarding the installation
and operation of the Cable/DSL Voice Router. Read below description to
solve your problems. If you can’t find an answer here, check the Linksys
website at www.linksys.com.
1. I Can’t connect to the Cable/DSL Router.
• The Cable/DSL Voice Router is properly installed, LAN connections
are OK, and it is powered ON.
• Ensure that your PC and the Cable/DSL Voice Router are on the same
network segment. If you are not sure, initiate the DHCP function, let
the PC get the IP address automatically.
• Ensure that your PC is using an IP Address within the default range of
192.168.1.2 to 192.168.1.254 and thus compatible with the Cable/DSL
Voice Router default IP Address of 192.168.1.1
• Also, the Subnet Mask should be set to 255.255.255.0 to match the
Cable/DSL Router. In the Cable/DSL Voice Router, you can check
these settings by using Control Panel-Network to check the Properties
for the TCP/IP protocol.
2. The Diag LED stays lit when it shouldn’t.
• The Diag LED lights up when the device is first powered up.
Meantime, the system will boot up itself and check for proper opera-
tion. After finishing the checking procedure, the LED turns off to show
the system is working fine. If the LED remains lit after this time, the
device is not working properly. Try to re-flash the firmware by assign-
ing a static IP address to the computer, then upgrade the firmware
again. If that doesn’t help, contact your dealer for further inspection.
3. I can’t browse through the Cable/DSL & Voice Router.
• Check if both ends of the network cable and power adapter are properly
connected. Check if the status LEDs on the front panel are functioning
properly.
• If using Windows 95 or Windows 98, check the TCP/IP setup on the
client side. Run "winipcfg" by clicking on the Start button, then select-
ing Run. The PC should have an IP address of 192.168.1.xxx ("xxx" is
from 2 to 254.) Subnet Mask is 255.255.255.0, the default gateway IP
37
EtherFast
®
Cable/DSL & Voice Router powered by Net2Phone
The Speed Dial setting allows users to program phone numbers that can be
dialed quickly using “shortcut” type words. Ten different numbers can be
input for speed dial through the voice router.
To program the “Fast Dial” option:
1. Enter the shortcut for the first telephone number you wish to program
into the first available “Fast Dial” box.
2. Enter the telephone number associated with that shortcut in the correspon-
ding phone number box.
3. Enter a description for the number in the “Description” box.
4. When calling, pick up the receiver and dial the shortcut of the telephone
number you wish to call. For example, the shortcut shown above would
be “*1”.
Speed Dial
36
Instant Broadband
TM
Series
