3
3. Components:
Transmitter, Card Pager, Home Station
4. Installation
•
Unlock pager by switching the pin on the bottom of
the pager
to the right
.
•
Activate pager by pressing for 4 seconds until a
beep sound is heard.
•
Insert all pagers in the Home Station.
•
Connect the Home Station to the transmitter through
the USB cable and turn it on.
•
Plug the transmitter to electric current and turn it on.
•
Wait for the pagers to recharge (red LED aside every
Home Station slot to stop blinking.
5. Card pager configuration / identification
Pager ID registration procedures:
•
Insert the pager(s) into the Home Station
(make sure it is connected to the transmitter)
•
Press the Reg. button on the transmitter.
•
Press the nr. of the first pager of the sequence.
•
Press: _ ” button.
•
Press the nr. of the last pager of the sequence,
so the display shows something like “ID: 1-10”.
•
Press (Enter).
The “PT-T100” model is a transmitter
which can call a specific range of pagers.
The programming of pagers can be done
through transmitters.
Signal range reaches up to 100 meters
(330 ft).
The signal range varies depending on
building’s structure and wall thickness.
Additional amplifiers may be installed to
increase signal range(optional: see pg.14).
The Home Station is an interface between the
transmitter and the pager. It can be
connected to the transmitter through a USB
supplied. It can simultaneously recharge 10
pagers(PT-C100) and 3 pagers(PT-C030).
Next to each rechargeable slot are two LED’s;
one red (charging status indicator) and the
other green (pager programming indicator).
Programming pagers can be done through
the Home Station as well.
The wireless pagers are pocket-sized and
can be hung on neck, on a belt, or on the
wrist with apt accessories.
The pagers run on internal lithium
rechargeable batteries.
The pagers are recharged by positioning it
into its unique slot on the Home Station.
PT-T100
PT-C100
PT-D100
Tasto
On/off