Link Communications RLC-4, Manual, Page: 75 / 228

5-7
RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
062: Change the Beginning of Command Names
This command allows you to change the first one, two or three digits of the names of a range of
commands. If you specify one digit, all of the command names in the range you specified will
become four digits long. If you specify 2, they will be 5 long (and 3, 6). The last three digits of a
command's name can not be changed with this command (see command 010). This is to avoid
accidently assigning the same name to multiple commands.
<062> bbb eee d Change the first digit of the name in a range
<062> bbb eee dd Change the first and second digits of the name in a range
<062> bbb eee ddd Change the first, second and third digits of the name in a range
<062> bbb eee Strip off enough leading digits to make each command name
three digits or less. This will "undo" most of the changes made
with the above formats.
Parameters:
- 062 is the default command name.
- BBB is the number of the first command in the range that you want to change
- EEE is the number of the last command in the range that you want to change
- D or DD or DDD are the new first digits of the command names
CW Response:
BBB TO EEE IS D or DD orDDD
Notes:
You should avoid renaming command 080, or the 'N' method of entering commands from the
serial port will quit working. See Appendix F for more information about using 'N'.
Any commands in the range that have names shorter than three digits long will have zeros added
before their names to make them three digits long before this command changes the other digits.
For example, 062 010 050 A changes C010 to A010, 123 to A123, A1 to A0A1, and # to
A00#.
Example 1:
You want to change the names of all of the commands in the controller to start with '#' so that
they can be executed from a 12-key touch tone pad:
<062> 000 249 # <unkey>