Link-Belt PULSE, Calibration Manual, Page: 14 / 69

Calibrate Boom Length
– Full Power Booms
Note: Adjust soft stop on PAT reel first. Refer to
“Calibrate Boom Length-PAT Reel Initial Setup”.
1. In Access Level 2, Calibration and Programming,
Use Buttons 2 and/or 4 to highlight Boom Length.
2. Press Button 3 to enter Boom Length.
4. Fully retract the boom for the first calibration point -
with the boom fully retracted, press Button 3 which
will place a green checkmark at the
Set Fully Re-
tracted position as in the example above.
Note: Pressing Button 2 and/or 4 will scroll
through the extended sections to be calibrated
highlighting them in BOLD type.
5. Using the Boom Telescope Override Switches ex-
tend the Tip and Outer boom sections.
6. Press Button 3 to set the extended section boom
length and a green checkmark will appear indicat-
ing the calibration point. Do not retract Tip and
Outer boom sections, proceed to Step 7.
7. Using the Boom Telescope Override Switches ex-
tend the Center boom section (if equipped, if not
equipped proceed to Step 9).
8. Press Button 3 to set the extended section boom
length and a green checkmark will appear indicat-
ing the calibration point.
9. Fully extend the boom.
10. When completed all sections will have green
checkmarks indicating all sections have been cal-
ibrated.
11. Boom Length Calibration is now complete.
3. Use Buttons 2 and/or 4 to highlight Set Fully Re-
tracted.