Linhai LH400ATV-2B, Owner'S/Operator'S Manual

Page: 64 / 103

14.
BATTERY
Battery Removal
1. Disconnect hold down straps holding the electrical box and battery in
position and remove battery cover.
2. Remove the battery vent tube from the battery.
3. Disconnect the black (negative) battery cable first.
4. Disconnect the red(positive) battery cable next.
5. Lift the battery out of the ATV, being careful not to tip it sideways and spill
electrolyte.
CAUTION
If electrolyte spills, immediately wash it off with a solution of one tablespoon
baking soda and one cup water to prevent damage to the ATV.
Battery Installation and Connections
WARNING
To avoid the possibility of explosion, always connect battery cables in the order
specified. Red (positive) cable first; black (negative) cable last. An exploding
battery can cause serious injury or death.
Battery terminals and connections should be kept free of corrosion.
If cleaning is necessary, remove the corrosion with a stiff wire brush. Wash
with a solution of one tablespoon baking soda and one cup water. Rinse well
with tap water and dry off with clean rags. Coat the terminals with dialectic
grease or petroleum jelly. Be careful not to allow cleaning solution or tap water
into the battery.
1. Set the battery in its holder.
2. Install the battery vent tube. It must be free from obstructions and securely
installed. If not, battery gases could accumulate and cause an explosion.
The tube should be routed away from the frame and body to prevent