8
9
Installing your unit – ABS Clip Model
NOTE: Pay close attention to the assembly sequence of mount assembly
components, as they have been correctly assembled during production.
Remove the fastening ring by releasing
1.
the lock catch.
Remove mount assembly from disposer.
2.
Unscrew support ring from sink flange and
3.
remove protector gasket and fibre gasket.
You are now left with sink flange and
rubber gasket.
The rubber gasket is used instead of
4.
plumbers putty with stainless steel sinks.
Other sinks (ceramic, stone etc) will require
putty.
If no putty is required, insert sink flange
5.
through rubber gasket into sink opening.
Do not rotate sink flange once it is seated.
If using putty instead of the gasket, form
6.
a ring around the sink flange. Insert flange
into sink opening, press down hard to
squeeze out excess putty. From under
sink, trim off excess putty flush with
bottom edge of sink opening.
From underneath sink, slip fibre gasket
7.
onto exposed sink flange. With arrows
pointing up, screw support ring onto the
sink flange, hand tighten until the sink
flange will not move. At this point you may
want to insert stopper in sink and fill with
water to check sink flange seal and insure
there are no leaks.
Lift the machine up with two hands and let the sink flange insert into the
8.
splash guard and make sure that the groove on the inside of the splash guard
fits over lip on sink flange. At the same time, make sure that the discharge
outlet faces towards the location of the drain pipe.
Put the fastening ring around the splash guard and lock the buckle, checking
9.
that the installation is firm and stable. If everything is OK, go on to install the
elbow and make the connection to the waste pipe.
1
2
3
4
5
LINEAR MANUAL new.indd 9
29/4/10 14:48:34
