In a basic system, using a single amplifier, set the amp gain to minimum, turn the
source unit up until it just starts to distort, then back down slightly. This is the
point where the output of the source is cleanest. Now, bring the
gain of the amp
up until it just starts to distort and back down slightly. This will allow the source
and amp to reach maximum usable output at the same time.
GENERAL TROUBLESHOOTING
NO SOUND
Check all connections. Check main power fuse. Check accessory fuse of your
vehicle. Check to see that +12Vdc is present at the amplifier on the power wire,
and on the red/white remote turn-on wire. Check for a solid ground connection.
Check that the main music source is putting out signal.
BLOWS FUSES
check all connections to be sure no wires are touching each other or the chassis
of the vehicle or any other equipment in your install. Check that your speakers
are in proper working order.
SHUTS OFF
As this amplifier is equipped with thermal and short circuit shut-down electronics,
in the event of high ambient temperature or improper speaker impedances, the
amp will turn itself off. To avoid damage to speakers, turn down the volume while
waiting for the amp to turn itself back on. If this occurs repeatedly, use a fan to
cool the amplifier and check for proper speaker loads and connections.
SERVICE OR REPAIR
To obtain modification, service or repair, please contact our
ONLY Authorized
LINEAR POWER™
P
roduct Service Center
:
T.I.P.S. INC.
3455 Lanell lane, Pearl, MS 39208
(601) 932-8477
E-mail:
™
3 4 5 5 L A N E L L L A N E, P E A R L, M S 3 9 2 0 8 (6 0 1) 9 3 2 – 8 4 7 7
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
LINEAR POWER™ is a trademark of Linear Power, Inc.
4
