INSTRUCTIONS
Read the following instructions through completely. If they appear too
complicated, we recommend that you have an authorized
LINEAR POWER™
Dealer perform the installation.
WIRING
1.Disconnect battery ground cable before making any power connections.
2.BLACK WIRE
- Connect this wire to a clean, unpainted metal surface in the
car.
3.RED WIRE
- Connect this wire to the battery's positive (+) terminal. A fuse
should be installed within 18 inches of the battery connection and another fuse
where the connection to the amplifier is made. Remember, use the proper size
fuses. The
1001SW
©
uses a 25-amp fuse.
WARNING: USING OVERSIZED FUSES IS DANGEROUS AND WILL
DAMAGE YOUR AMPLIFIER.
4. RED AND WHITE WIRE
- is connected to the radio's "turn on lead" or power
antenna remote lead. When neither of these exists you may connect this lead to
a +12 Volt wire that is on when the car ignition is on or in accessory position.
5. RCA (phono) JACKS
- The
1001SW
©
has 2 sets, one marked
INPUT
and the
second marked
HIGH PASS OUT
. The first set will accommodate either high or
low level signals. If possible use good quality shielded cable for low-level inputs.
For high-level inputs solder low power speaker wires to RCA connectors with the
center pin as positive.
The second set of RCA jacks marked
HIGH PASS OUT
are for use with a
second amplifier used to run midrange and treble speakers without the need for
an external active crossover. (See crossover selection for more information).
6. SPEAKER CONNECTION
- Insert speaker wires into plug positive (+) to the
left slot and negative (-) to right slot. The
1001SW
©
is rated at 4 ohms and is
capable of operating into 2 ohms minimum (
do not
use less than a 2 ohm load
as this will cause amplifier failure and damage your amplifier).
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
LINEAR POWER™ is a trademark of Linear Power, Inc.
2
