Linear Acoustic AERO.qc User Guide
Detailed Operation
31
play which is nice to look at but harder to use when calibrating low frequencies.
A typical value in the 20-50 region is useful for analyzing the frequency response
of an input signal, higher numbers for room calibration.
4.3
Monitoring Settings (Optional)
If the Monitoring option is installed, a separate set of inputs and outputs are available to
allow auditioning of the Main program audio and audio from eight external monitor inputs
arranged as 5.1+2 or 4 x stereo.
Figure 4-6
Monitor Source Select
These signals can all be downmixed to LtRt, LtRT2, or LoRo and can also then be upmixed
for compatibility testing, or downmixed to mono. These settings can be accessed via that
Monitoring Settings -> Adjust Preset menus, and up to six separate monitor configura-
tions can be stored and then recalled via the front panel or by GPI control.
6
Main 5.1
Main LtRt
Main LtRt2
Main LoRo
Monitor Source
Select
Full (6)
LtRt, LtRt2, LoRo
Ext. Downmix
6
Ext 5.1 5.1
Ext 5.1 LtRt
Ext 5.1 LtRt2
Ext 5.1 LoRo
Ext 1 (Lf/Rf)
Ext 2 (C/LFE)
Ext 3 (Ls/Rs)
Ext 4
Main Program
Monitor Inputs
Monitor Output to
DAC and AES
LtRt, LtRt2, LoRo
Main Downmix
6
Monitor
Mode
Upmix
6
Mono
Summary of Contents for AERO.qc
